Proton Spectra From 800-{MeV} Protons on Selected Nuclides

Chrien, R.E. ; Krieger, T.J. ; Sutter, R.J. ; et al.
Phys.Rev.C 21 (1980) 1014, 1980.
Inspire Record 143625 DOI 10.17182/hepdata.5224

The emission of protons from targets of Li6, Li, C12, Al27, Ca40, V51, Zr90, and Pb under bombardment from 800 MeV protons has been studied using a high resolution proton spectrometer. Spectra were measured at laboratory scattering angles of 5°, 7°, 9°, 11°, 13°, 15°, 20°, 25°, and 30° with special emphasis on the quasifree region. Outgoing momenta corresponding to the region of pion production were examined at 11° and 15°. Absolute cross sections have been derived by reference to known (p,p) scattering data at 800 MeV. The quasifree scattering has been compared to a distorted-wave impulse approximation analysis by summing over the unobserved (struck) nucleon. The systematics of proton production and the applicability of the distorted-wave impulse approximation analyses are discussed. NUCLEAR REACTIONS (p,p′) on Li6, Li, C12, Al27, Ca40, V51, Zr90, Pb; Ep=800 MeV, θL=5° to 30°; quasielastic scattering, DWIA analysis.

50 data tables

APPROXIMATE SYSTEMATIC CROSS SECTION ERROR IS EQUAL TO +-6.5%.

APPROXIMATE SYSTEMATIC CROSS SECTION ERROR IS EQUAL TO +-6.5%.

APPROXIMATE SYSTEMATIC CROSS SECTION ERROR IS EQUAL TO +-6.2%.

More…

Excitation of the Delta (1232) resonance in proton - nucleus collisions

Trzaska, M. ; Pelte, D. ; Lemaire, M. -C. ; et al.
Z.Phys.A 340 (1991) 325-331, 1991.
Inspire Record 314551 DOI 10.17182/hepdata.15689

The excitation of theΔ resonance is observed in proton collisions on C, Nb and Pb targets at 0.8 and 1.6 GeV incident energies. The mass E0 and widthΓ of the resonance are determined from the invariant mass spectra of correlated (p, π±)-pairs in the final state of the collision: The mass E0 is smaller than that of the free resonance, however by comparing to intra-nuclear cascade calculations, this reduction is traced back to the effects of Fermi motion, NN scattering and pion reabsorption in nuclear matter.

22 data tables

WITHIN THE DETECTORS ACCEPTANCE RESULTS.

WITHIN THE DETECTORS ACCEPTANCE RESULTS.

WITHIN THE DETECTORS ACCEPTANCE RESULTS.

More…

Study of the production of charged pions, kaons, and protons in pPb collisions at sqrt(sNN) = 5.02 TeV

The CMS collaboration Chatrchyan, Serguei ; Khachatryan, Vardan ; Sirunyan, Albert M ; et al.
Eur.Phys.J.C 74 (2014) 2847, 2014.
Inspire Record 1242440 DOI 10.17182/hepdata.63972

Spectra of identified charged hadrons are measured in pPb collisions with the CMS detector at the LHC at sqrt(sNN) = 5.02 TeV. Charged pions, kaons, and protons in the transverse-momentum range pt approximately 0.1-1.7 GeV and laboratory rapidity abs(y) < 1 are identified via their energy loss in the silicon tracker. The average pt increases with particle mass and the charged multiplicity of the event. The increase of the average pt with charged multiplicity is greater for heavier hadrons. Comparisons to Monte Carlo event generators reveal that EPOS LHC, which incorporates additional hydrodynamic evolution of the created system, is able to reproduce most of the data features, unlike HIJING and AMPT. The pt spectra and integrated yields are also compared to those measured in pp and PbPb collisions at various energies. The average transverse momentum and particle ratio measurements indicate that particle production at LHC energies is strongly correlated with event particle multiplicity.

46 data tables
More…

Measurements of Forward Proton Production with Incident Protons and Charged Pions on Nuclear Targets at the CERN Proton Synchroton

The HARP collaboration Apollonio, M. ; Artamonov, A. ; Bagulya, A. ; et al.
Phys.Rev.C 82 (2010) 045208, 2010.
Inspire Record 857228 DOI 10.17182/hepdata.56498

Measurements of the double-differential proton production cross-section in the range of momentum 0.5 GeV/c < p < 8.0 GeV/c and angle 0.05 rad < \theta < 0.25 rad in collisions of charged pions and protons on beryllium, carbon, aluminium, copper, tin, tantalum and lead are presented. The data were taken with the large acceptance HARP detector in the T9 beam line of the CERN Proton Synchrotron. Incident particles were identified by an elaborate system of beam detectors and impinged on a target of 5 % of a nuclear interaction length. The tracking and identification of the produced particles was performed using the forward spectrometer of the HARP experiment. Results are obtained for the double-differential cross-sections mainly at four incident beam momenta (3 GeV/c, 5 GeV/c, 8 GeV/c and 12 GeV/c). Measurements are compared with predictions of the GEANT4 and MARS Monte Carlo generators.

84 data tables

Differential cross section for proton production with a negative pion beam and Beryllium target in the angular range 0.050 to 0.100 radians. The errors are the square-root of the diagonal elements of the covariant matrix.

Differential cross section for proton production with a negative pion beam and Beryllium target in the angular range 0.100 to 0.150 radians. The errors are the square-root of the diagonal elements of the covariant matrix.

Differential cross section for proton production with a negative pion beam and Beryllium target in the angular range 0.150 to 0.200 radians. The errors are the square-root of the diagonal elements of the covariant matrix.

More…

Cross-Sections of Large-Angle Hadron Production in Proton- and Pion-Nucleus Interactions V: Lead Nuclei and Beam Momenta from +/-3 Gev/c to +/-15 Gev/c

The HARP collaboration Bolshakova, A. ; Boyko, I. ; Chelkov, G. ; et al.
Eur.Phys.J.C 66 (2010) 57-117, 2010.
Inspire Record 838772 DOI 10.17182/hepdata.53811

We report on double-differential inclusive cross-sections of the production of secondary protons, charged pions, and deuterons, in the interactions with a 5% nuclear interaction length thick stationary lead target, of proton and pion beams with momentum from +/-3 GeV/c to +/-15 GeV/c. Results are given for secondary particles with production angles 20 to 125 degrees. Cross-sections on lead nuclei are compared with cross-sections on beryllium, copper, and tantalum nuclei.

360 data tables

Double-differential inclusive cross section for P production in P PB interactions at beam momentum 3 GeV/c in the polar angle range 20 to 30 degrees.

Double-differential inclusive cross section for P production in P PB interactions at beam momentum 3 GeV/c in the polar angle range 30 to 40 degrees.

Double-differential inclusive cross section for P production in P PB interactions at beam momentum 3 GeV/c in the polar angle range 40 to 50 degrees.

More…

PARTICLE PRODUCTION IN THE TARGET RAPIDITY REGION FROM HADRON NUCLEUS REACTIONS AT SEVERAL GEV

Shibata, T.A. ; Nakai, K. ; Enyo, H. ; et al.
Nucl.Phys.A 408 (1983) 525-558, 1983.
Inspire Record 197272 DOI 10.17182/hepdata.8739

Highly inelastic processes in hadron-nucleus reactions at several GeV have been studied by measuring multi-particle emission in the target-rapidity region. Events with no leading particle(s) but with high multiplicities were observed up to 4 GeV. Proton spectra from such events were well reproduced with a single-moving-source model, which implied possible formation of a local source. The number of nucleons involved in the source was estimated to be (3–5)A 1 3 from the source velocity and the multiplicity of emitted protons. In those processes the incident energy flux seemed to be deposited totally or mostly (>62;75%) in the target nucleus to form the local source. The cross sections for the process were about 30% of the geometrical cross sections, with little dependence on incident energies up to 4 GeV and no dependence on projectiles (pions or protons). The E 0 parameter in the invariant-cross-section formula E d 3 σ /d p 3 = A exp (− E / E 0 ) for protons from the source increases with incident energy from 1 to 4 GeV/ c , but seems to saturate above 10 GeV at a value E 0 = 60–70 MeV. Three components in the emitted nucleon spectra were observed which would correspond to three stages of the reaction process: primary, pre-equilibrium and equilibrium.

72 data tables

BEAM ERROR D(P)/P = 0.300 PCT. X ERROR D(EKIN)/EKIN = 8.00 PCT.

BEAM ERROR D(P)/P = 0.300 PCT. X ERROR D(EKIN)/EKIN = 8.00 PCT.

BEAM ERROR D(P)/P = 0.300 PCT. X ERROR D(EKIN)/EKIN = 8.00 PCT.

More…