The upgraded Collider Detector at Fermilab (CDF II) has a high bandwidth available for track based triggers. This capability in conjunction with the unprecedented integrated luminosity in excess of 1 fb −1 enables detailed studies of charm hadron production. CDF is now releasing first measurements of the prompt charm meson pair cross sections, which give access to QCD mechanisms by which charm quarks are produced in proton anti-proton collisions. Recent results on the spin alignment of J/ψ and ψ(2S) as well as on the relative production of the χc1(P1) and χc2(1P) challenge our understanding of the fragmentation of charm quarks into charmonium states.
The first prompt photon measurement from the CDF experiment at the Fermilab pp¯ Collider is presented. Two independent methods are used to measure the cross section: one for high transverse momentum (PT) and one for lower PT. Comparisons to various theoretical calculations are shown. The cross section agrees qualitatively with QCD calculations but has a steeper slope at low PT.
We report a measurement of the single top quark production cross section in 2.2 ~fb-1 of p-pbar collision data collected by the Collider Detector at Fermilab at sqrt{s}=1.96 TeV. Candidate events are classified as signal-like by three parallel analyses which use likelihood, matrix element, and neural network discriminants. These results are combined in order to improve the sensitivity. We observe a signal consistent with the standard model prediction, but inconsistent with the background-only model by 3.7 standard deviations with a median expected sensitivity of 4.9 standard deviations. We measure a cross section of 2.2 +0.7 -0.6(stat+sys) pb, extract the CKM matrix element value |V_{tb}|=0.88 +0.13 -0.12 (stat+sys) +- 0.07(theory), and set the limit |V_{tb}|>0.66 at the 95% C.L.
The dijet invariant mass distribution has been measured in the region between 120 and 1000 GeV/c2, in 1.8-TeV pp¯ collisions. The data sample was collected with the Collider Detector at Fermilab (CDF). Data are compared to leading order (LO) and next-to-leading order (NLO) QCD calculations using two different clustering cone radii R in the jet definition. A quantitative test shows good agreement of data with the LO and NLO QCD predictions for a cone of R=1. The test using a cone of R=0.7 shows less agreement. The NLO calculation shows an improvement compared to LO in reproducing the shape of the spectrum for both radii, and approximately predicts the cone size dependence of the cross section.
An analysis of high-transverse-momentum electrons using data from the Collider Detector at Fermilab (CDF) of p¯p collisions at s=1800 GeV yields values of the production cross section times branching ratio for W and Z0 bosons of σ(p¯p→WX→eνX)=2.19±0.04(stat)±0.21(syst) nb and σ(p¯p→Z0X→e+e−X)=0.209±0.013(stat)±0.017(syst) nb. Detailed descriptions of the CDF electron identification, background, efficiency, and acceptance are included. Theoretical predictions of the cross sections that include a mass for the top quark larger than the W mass, current values of the W and Z0 masses, and higher-order QCD corrections are in good agreement with these measured values.
We report a measurement of the ttbar production cross section using dilepton events with jets and missing transverse energy in ppbar collisions at a center-of-mass energy of 1.96 TeV. Using a 197 +/- 12 pb-1 data sample recorded by the upgraded Collider Detector at Fermilab, we use two complementary techniques to select candidate events. We compare the number of observed events and selected kinematical distributions with the predictions of the Standard Model and find good agreement. The combined result of the two techniques yields a ttbar production cross section of 7.0 +2.4/-2.1(stat.) +1.6/-1.1(syst.) +/- 0.4(lum.) pb.
A measurement of the inclusive bottom jet cross section is presented for events containing a $Z$ boson in $p\bar{p}$ collisions at $\sqrt{s}=1.96$ TeV using the Collider Detector at Fermilab. $Z$ bosons are identified in their electron and muon decay modes, and $b$ jets with $E_T>20$ GeV and $|\eta|<1.5$ are identified by reconstructing a secondary decay vertex. The measurement is based on an integrated luminosity of about 330 ${\rm pb}^{-1}$. A cross section times branching ratio of $\sigma (Z+b {\rm jets}) \times {\cal B}(Z \to \ell^+ \ell^-)= 0.93 \pm 0.36$ pb is found, where ${\cal B}(Z\to \ell^+ \ell^-)$ is the branching ratio of the $Z$ boson or $\gamma^*$ into a single flavor dilepton pair ($e$ or $\mu$) in the mass range between 66 and 116 GeV$/c^2$. The ratio of $b$ jets to the total number of jets of any flavor in the $Z$ sample, within the same kinematic range as the $b$ jets, is $2.36 \pm 0.92%$. Here, the uncertainties are the quadratic sum of statistical and systematic uncertainties. Predictions made with NLO QCD agree, within experimental and theoretical uncertainties, with these measurements.
We present a measurement of the shapes of b-jets using 300 pb-1 of data obtained with the upgraded Collider Detector at Fermilab (CDF II) in p pbar collisions at center of mass energy sqrt{s}=1.96 TeV. This measurement covers a wide transverse momentum range, from 52 to 300 GeV/c. Samples of heavy-flavor enhanced jets together with inclusive jets are used to extract the average shapes of b-jets. The b-jets are expected to be broader than inclusive jets. Moreover, b-jets containing a single b-quark are expected to be narrower than those containing a b bbar pair from gluon splitting. The measured b-jet shapes are found to be significantly broader than expected from the PYTHIA and HERWIG Monte Carlo simulations. This effect may arise from an underestimation of the fraction of b-jets originating from gluon splitting in these simulations.
We present a measurement of the inclusive jet cross section in p-pbar collisions at sqrt{s}=1.96 TeV based on data collected by the CDF II detector with an integrated luminosity of 1.13 fb^-1. The measurement was made using the cone-based Midpoint jet clustering algorithm in the rapidity region of |y|<2.1. The results are consistent with next-to-leading-order perturbative QCD predictions based on recent parton distribution functions (PDFs), and are expected to provide increased precision in PDFs at high parton momentum fraction x. The results are also compared to the recent inclusive jet cross section measurement using the k_T jet clustering algorithm, and we find that the ratio of the cross sections measured with the two algorithms is in agreement with theoretical expectations over a large range of jet transverse momentum and rapidity.
We report on measurements of the inclusive jet production cross section as a function of the jet transverse momentum in pp-bar collisions at sqrt{s} = 1.96 TeV}, using the k_T algorithm and a data sample corresponding to 1.0 fb^-1 collected with the Collider Detector at Fermilab in Run II. The measurements are carried out in five different jet rapidity regions with |yjet| < 2.1 and transverse momentum in the range 54 < \ptjet < 700 GeV/c. Next-to-leading order perturbative QCD predictions are in good agreement with the measured cross sections.