The polarization parameter in proton-proton scattering has been measured at incident proton kinetic energies of 1.7, 2.85, 3.5, 4.0, 5.05, and 6.15 BeV and for four-momentum transfer squared between 0.1 and 1.0 (BeV/c)2. The experiment was done with an unpolarized proton beam from the Bevatron striking a polarized proton target. Both final-state protons were detected in coincidence and the asymmetry in counting rate for target protons polarized parallel and antiparallel to the scattering normal was measured. The maximum polarization was observed to decrease from 0.4 at 1.7 BeV to 0.2 at 6.1 BeV. The maximum of the polarization at all energies studied occurs at a four-momentum transfer squared of 0.3 to 0.4 (BeV/c)2.
'1'.
'2'.
'3'.
Data on 6.2 GeV/ c π − p and K − p elastic scattering cross sections are presented in the range 0.3 < − t < 10.7 (GeV/ c ) 2 .
No description provided.
No description provided.
The polarization parameter has been measured for π − p elastic scattering in the backward region at 3.5 GeV/ c incident momentum. The experimental set-up consisted of a polarized target in a spectrometer magnet, hodoscopes and wire spark chambers. Data are presented for the range −0.95< u ⩽−0.19 GeV 2 . An isospin analysis has been carried out to separate the I u = 1 2 and I u = 3 2 contributions.
BACKWARD SCATTERING.
A polarized proton beam extracted from SATURNE II was scattered on an unpolarized CH 2 target. The angular distribution of the beam analyzing power A oono was measured at large angles from 1.98 to 2.8 GeV and at 0.80 GeV nominal beam kinetic energy. The same observable was determined at the fixed mean laboratory angle of 13.9° in the same energy range. Both measurements are by-products of an experiment measuring the spin correlation parameter A oon .
Analysing power measurements at a fixed laboratory angle of 13.9 degrees.
No description provided.
No description provided.
Data on polarization in backward elastic π + p scattering at 2.0, 3.5 and 4.0 GeV/ c are presented. The data at 2.0 GeV/ c are compared with the result of a recent phase-shift analysis. Our data at 3.5 and 4.0 GeV/ c , and existing data above 3 GeV/ c , show no significant energy dependence of the polarization over the measured u -range. A comparison with Regge models and with results from amplitude analysis is made.
No description provided.
No description provided.
No description provided.
Data have been obtained for the polarization analyzing power Ay(θ) in pp elastic scattering from near 30° to 90° (c.m.) at 643, 787, and 796 MeV. Relative uncertainties are typically ± 0.003 with an overall normalization uncertainty of {+1}{−0.5}%. Data are not consistent with existing phase-shift analyses.
No description provided.
No description provided.
No description provided.
Excitation functions AN(pp,Θc.m.) of the analyzing power in pp→ elastic scattering have been measured with a polarized atomic hydrogen target for projectile momenta pp between 1000 and 3300 MeV/ c. The experiment was performed for scattering angles 30°≤Θc.m.≤90° using the recirculating beam of the proton storage ring COSY during acceleration. The resulting excitation functions and angular distributions of high internal consistency have significant impact on the recent phase shift solution SAID SP99, in particular, on the spin triplet phase shifts between 1000 and 1800 MeV, and demonstrate the limited predictive power of single-energy phase shift solutions at these energies.
No description provided.
No description provided.
No description provided.
Measurements at 18 beam kinetic energies between 1975 and 2795 MeV and at 795 MeV are reported for the pp elastic-scattering single spin parameter Aooon=Aoono=AN=P. The c.m. angular range is typically 60–100°. These results are compared to previous data from Saturne II and other accelerators. A search for energy-dependent structure at fixed c.m. angles is performed, but no rapid changes are observed.
Measured values of the P P analysing power at kinetic energy 0.795 GeV. Therelative and additive systematic errors are +- 0.018 and 0.0007.
Measured values of the P P analysing power at kinetic energy 1.975 GeV. Therelative and additive systematic errors are +- 0.045 and 0.002.
Measured values of the P P analysing power at kinetic energy 2.035 GeV fromrun I. The relative and additive systematic errors are +- 0.044 and 0.002.
Experimental results are presented for the pp elastic-scattering single spin observable Aoono=Aooon=AN=P, or the analyzing power, at 19 beam kinetic energies between 1795 and 2235 MeV. The typical c.m. angular range is 60–100°. The measurements were performed at Saturne II with a vertically polarized beam and target (transverse to the beam direction and scattering plane), a magnetic spectrometer and a recoil detector, both instrumented with multiwire proportional chambers, and beam polarimeters.
Measurement values of the P P analysing power at kinetic energy 1.795 GeV. The relative and additive systematic errors are +- 0.106 and 0.003.
Measurement values of the P P analysing power at kinetic energy 1.845 GeV. The relative and additive systematic errors are +- 0.068 and 0.001.
Measurement values of the P P analysing power at kinetic energy 1.935 GeV. The relative and additive systematic errors are +- 0.091 and 0.003.
The pp elastic scattering analyzing power was measured in small energy steps in the vicinity of the accelerator depolarizing resonance $\gamma G= 6 $ at 2.202 GeV.
Analysing power measurements in P P elastic scattering LEN(C=CU) is the length of CU degrader thickness used in each group.
Analysing power measurements in P P elastic scattering LEN(C=CU) is the length of CU degrader thickness used in each group.
Analysing power measurements in P P elastic scattering LEN(C=CU) is the length of CU degrader thickness used in each group.
Forum