None
'1'. '2'. '3'.
No description provided.
No description provided.
The differential cross section for neutron-deuteron elastic scattering was measured for four-momentum transfers 0.3 < − t < 2.0 (GeV/c) 2 with incident neutron momenta between 6 and 12.5 GeV/c. The measurement was made with spark chambers at the Argonne ZGS. Results are compared with proton-deuteron elastic scattering at comparable energies as a test of isospin invariance in strong interactions and with the predictions of the Glauber multiple scattering theory. Very good agreement is found.
UNPUBLISHED DATA.
No description provided.
UNPUBLISHED DATA.
We have measured total cross sections for neutrons on protons, deuteriom, beryllium, carbon, aluminium, iron, copper, cadmium, tungsten, lead, and uranium for momenta between 30 and 300 GeV/ c . The measurements were carried out in a small-angle neutral beam at Fermilab. Typical accuracy of the data is 0.5 to 1%. The cross sections are consistent with an A 0.77±0.01 dependence over the entire momentum range. The cross sections are compared with theoretical predictions. Agreement is found only if inelastic screening is included. Nuclear radii obtained from our data are in good agreement with previous determinations.
No description provided.
No description provided.
No description provided.
The polarization parameter in elastic proton-proton scattering has been measured at 0.75, 1.03, 1.32, 1.63, 2.24, and 2.84 GeV by employing a double-scattering technique. An external proton beam from the Brookhaven Cosmotron was focused on a 3 in.-long liquid-hydrogen target and the elastic recoil and scattered protons were detected in coincidence by scintillation counters. The polarization of the recoil beam was determined from the azimuthal asymmetry exhibited in its scattering from a carbon target. This asymmetry was measured by a pair of scintillation-counter telescopes which symmetrically viewed the carbon target. The analyzing power of this system was previously determined in an independent calibration experiment employing a 40%-polarized proton beam at the Carnegie Institute of Technology synchrocyclotron. False asymmetries were cancelled to a high order by periodically rotating the analyzer 180° about the recoil beam line. Spark chambers were utilized to obtain the spatial distribution of the beam as it entered the analyzer; this information allowed an accurate determination of the corrections necessary to compensate for any misalignment of the axis of the analyzer relative to the incident-beam centroid. Values of the polarization parameter as a function of the center-of-mass scattering angle are given for each incident beam energy. The predictions of the Regge theory for polarization in elastic proton-proton scattering and recently published phase-shift solutions are compared with the experimental results. Surprisingly good agreement with the Regge predictions is found despite the low energies involved.
'ALL'.
No description provided.
No description provided.
The differential cross section for neutron-proton elastic scattering was measured in the diffraction region with incident-neutron momenta between 8 and 30 GeV/c. The experiment was a spark-chamber-counter experiment, conducted at the alternating-gradient synchrotron. Results are presented and compared with currently available lower energy np data and comparable energy pp data.
No description provided.
We have measured total cross sections for p−p scattering with the results σT=40.42±0.27 mb at 200 GeV/c and 40.40 ± 0.28 mb at 300 GeV/c. Our 300-GeV/c result is significantly higher than published data from the CERN intersecting storage rings. Our data, taken together with the Serpukhov data, indicate that the cross section rises ≅ 2 mb between 60 and 250 GeV. The variation of the cross section with energy may be more complicated than the a+blnsα behavior commonly assumed for Elab≳50 GeV.
Axis error includes +- 0.0/0.0 contribution (QUOTED ERRORS ARE COMBINED STATISTICAL AND SYSTEMATIC).
We present results of measurements of the n−p total cross section between 30 and 280 GeV/c. The measurements were carried out with a neutron beam by using the standard transmission technique and a liquid-hydrogen target. A total-absorption calorimeter was used to determine the neutron energy. Our measurements, which have an accuracy of ∼1%, indicate a smooth rise of approximately 1.5 mb between 50 and 280 GeV/c. The combined n−p and p−p data above 20 GeV/c are well fitted by the expression σ=38.4+0.85|ln(s95)|1.47 mb.
MOST DATA TAKEN WITH 300 GEV/C INCIDENT PROTONS TO PRODUCE THE NEUTRON BEAM, WITH SOME ALSO USING 200 GEV/C PROTONS.
Direct measurements were made of neutron-proton elastic scattering differential cross sections at high energies. A neutron beam with a continuous momentum spectrum between 1.2 and 6.7 GeV/c was scattered off a liquid hydrogen target, and spark chambers were used to determine the neutron scattering angle and, in a proton spectrometer, to measure the momentum and scattering angle of the recoil proton. Differential cross sections are presented over the incident neutron momentum range in intervals of the order of 0.5-GeV/c wide. The cross sections have an exponential peak in the forward direction and then flatten and become isotropic about the 90° c.m. scattering angle. At larger angles, the cross sections again rise towards the expected charge-exchange peak, which was not within the range of this experiment. There is little evidence of any other structure in the cross section. Values are presented for the slope of the diffraction peak, and comparisons are made between these slopes, and the 90° c.m. cross sections, for pp and np elastic scattering. The results presented here differ from those previously reported because of an error in a Monte Carlo calculation and in the availability of improved data on the real part of the np elastic scattering amplitude. At 5 GeV/c, a direct comparison of pp and np data allows the I=0 differential cross section to be extracted. The np data have been fitted in powers of cosθc.m. for |cosθc.m.|<0.8 for each energy range.
No description provided.
No description provided.
No description provided.
In this letter, measurements of the shared momentum fraction ($z_{\rm{g}}$) and the groomed jet radius ($R_{\rm{g}}$), as defined in the SoftDrop algorihm, are reported in \pp collisions at $\sqrt{s} = 200$ GeV collected by the STAR experiment. These substructure observables are differentially measured for jets of varying resolution parameters from $R = 0.2 - 0.6$ in the transverse momentum range $15 < p_{\rm{T, jet}} < 60$ GeV$/c$. These studies show that, in the $p_{\rm{T, jet}}$ range accessible at $\sqrt{s} = 200$ GeV and with increasing jet resolution parameter and jet transverse momentum, the $z_{\rm{g}}$ distribution asymptotically converges to the DGLAP splitting kernel for a quark radiating a gluon. The groomed jet radius measurements reflect a momentum-dependent narrowing of the jet structure for jets of a given resolution parameter, i.e., the larger the $p_{\rm{T, jet}}$, the narrower the first splitting. For the first time, these fully corrected measurements are compared to Monte Carlo generators with leading order QCD matrix elements and leading log in the parton shower, and to state-of-the-art theoretical calculations at next-to-leading-log accuracy. We observe that PYTHIA 6 with parameters tuned to reproduce RHIC measurements is able to quantitatively describe data, whereas PYTHIA 8 and HERWIG 7, tuned to reproduce LHC data, are unable to provide a simultaneous description of both $z_{\rm{g}}$ and $R_{\rm{g}}$, resulting in opportunities for fine parameter tuning of these models for \pp collisions at RHIC energies. We also find that the theoretical calculations without non-perturbative corrections are able to qualitatively describe the trend in data for jets of large resolution parameters at high $p_{\rm{T, jet}}$, but fail at small jet resolution parameters and low jet transverse momenta.
The data points and the error bars represent the mean $p_{\rm{T, jet}}^{\rm{det}}$ and the width (RMS) for a given $p_{\rm{T, jet}}^{\rm{part}}$ selection $R = 0.4$.
The data points and the error bars represent the mean $p_{\rm{T, jet}}^{\rm{det}}$ and the width (RMS) for a given $p_{\rm{T, jet}}^{\rm{part}}$ selection $R = 0.2$.
The data points and the error bars represent the mean $p_{\rm{T, jet}}^{\rm{det}}$ and the width (RMS) for a given $p_{\rm{T, jet}}^{\rm{part}}$ selection $R = 0.6$.
The analyzing power,$A_{oono}$, and the polarization transfer observables$K_{onno}$,$K_{os''so}$
Position 'A' (see text for explanation).
Position 'A' (see text for explanation).
Position 'A' (see text for explanation).
Forum